DM800guy
-
Posts
84 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Everything posted by DM800guy
-
Good Evening, If these parts are still avaliable pm me. Thank You
-
WTB: E6 Injection Pump Drive Shaft Housing & Front Timing Cover
DM800guy replied to mnslim's topic in Parts Wanted
Good Evening, Private message me may have a complete pump on a 237. -
What are you looking to get for this truck in a box.
-
Have one which is a diesel version.
-
1965 mack b61 with parts and r model hood cheap
DM800guy replied to Joe palka's topic in Trucks for Sale
Is this truck still for sale? -
You still looking?
-
The engine i have is 1979 235 with spin on filters. It's the later model. If you would like a picture of it PM me and i'll send it right over to you. As for the fuel curve gentleman. If the pump on the engine is set up for a six speed lo-hole which most of them were cause the 18 speeds went away in the early 70's to my knowledge but i could be wrong. The 18's and triplex's we are all talking about operate from 1500-2100. The lo-hole with the triple countershaft operates around 1200-1850. So the timing on the injection pump for the fuel delivery is different. Hence the term fuel curve.
-
I have a decent 237hp that would go right in there minimal mods and minimal rebuild. You need to do the injection pump over for the right fuel curve.
-
We have a single axle B-61LT project for sale with a pile of parts. Two cabs, two hoods, one set of fenders. One extra 9 speed overdrive transmission, also have a spare front and rear axle that goes with it. 20" spokes on the truck, and 22" spokes on the spare axles. Has a 235hp motor that goes with it and an extra radiator support. $3,500 takes all.
-
It's good for parts or if you wanna run it.
-
Is it still for sale?
-
Good Evening, I believe i have the passenger side panel your looking for. Let me know if you still need it.
-
Good Evening, Would a running 250hp work for you?
-
Good Evening, Are you still in need of rims?
-
I have a set of square diamond plate fuel tanks for sale, minor dents. Off of a 1954 b-61 tractor.
-
Good Evening, I have a few if you still them. Mario
-
Good Evening, If your still looking i have a set. Mario
-
B Model muffler heat shield
DM800guy replied to richard-b61's topic in Antique and Classic Mack Trucks General Discussion
Are you looking for the alummium muffer sheild? -
Do you still have the grille shell?
-
Yes the tank with the mounting brackets.
-
I have a complete 673p engine with an air starter that is working for sale. I will break it up.
-
You have a phone number you can be reached at.
-
DM-800 Dump Truck
DM800guy replied to j hancock's topic in Antique and Classic Mack Trucks General Discussion
Anybody know where there is some Dm800 parts sitting. Looking for fenders some 8 inch rims and a good green steering wheel. -
New York Macks 2
DM800guy replied to RFCDrum's topic in Antique and Classic Mack Trucks General Discussion
That was a glider built by Tony Capabaianco from Amityville -
Connecticut Construction Trucks
DM800guy replied to BKrois's topic in Antique and Classic Mack Trucks General Discussion
Awesome pictures, and you guys know anyone that may have some 8.00x24" rims. Also looking for an original green steering wheel and front fenders for a 1966 Dm800. Do they have 1100x24" tires up that way in Conn. Thank You
BMT Forum Logo
