Jump to content

IH Farms 2

Bulldog
 View Profile  See their activity

  • Posts

    262

  • Joined

  • Last visited

 Content Type 

Everything posted by IH Farms 2

  1. IH Farms 2
    Spotted this in storkmack's backyard at the delong elevator
  2. IH Farms 2
    They done cost that much just change them take the tire off. Weld the nut to the stud and back them out with an impact and install new studs and nuts
  3. IH Farms 2
    Sparky hauled my combine up from southern Illinois couple years ago I'll get my wife to find the pictures and post them.
  4. IH Farms 2
    It's a glider from what I can tell the vin starts with a 2m instead of a 1m. This truck has been for sale for over 2 years at least in various places
  5. IH Farms 2
    I put por 15 on my frame and their por 15 top coat under my 5th wheel. Couple months later had to take the 5th off again and you could peel it off in large sheets. It was old paint so not sure if that was the issue or what
  6. IH Farms 2
    Its telling you traffic will be getting bad and its quitting time. What is the fuel level? Maybe thats the time it gets low enough and there is a crack in the draw tube?
  7. IH Farms 2
    You can run it disconnected to see if the cable is turning. It kinda sounds like the adapter off of the trans may not be working correctly so I'd check that out
  8. IH Farms 2
    I was gonna yell at you ranchhopper on the cb today but I don't remember the channel you guys run nice looking rd you have now.
  9. IH Farms 2
    10'X10' door and at least 20' for length should be plenty for storage can't have a tall stack though. Mine on 22 low pros and a 72" muffler and stack height is under 12'
  10. IH Farms 2
    I'm sure the grab handles where an option. Mine has them makes getting up on the battery boxes to clean the windsheilds a little easier and safer
  11. IH Farms 2
    It looks good compared to some of the junk in towards chicago running around
  12. IH Farms 2
    I screwed it in where the cable went just have to use the plastic tip thats on the cable like I said.
  13. IH Farms 2
    This is the one I used had to modify it with an original drive tang. Cut it down and drilled a hole in the middle The speedometer head is autometer part number 1480. Had to calibrate it basically find a measured 2 miles and drive it following the instructions on how to set it up I have a T2100 at the moment want a t2130
  14. IH Farms 2
    Sure will I can even give part numbers from Summit racing once I get home tonight
  15. IH Farms 2
    I noticed that after I ordered the unit that still drives off of where the cable went that they have GPS modules that'll drive the speedometer
  16. IH Farms 2
    Yep it'll be kinda handy to have a trip odometer too
  17. IH Farms 2
    So I had the cable break on me taught no big deal. Went to mack bought a new one $120 later installed it. Monday went to work lasted 8 hrs. So when I got home started cruising Summit Racing's website found an autometer guage and a signal generator that'd screw into the trans. Finally got a chance today to install it real simple and easy had to modify the the generator drive with the stock tang which went well and 5 wires to hook up and route
  18. IH Farms 2
    Well next week I'll be headed to bedford park 3 times a day so keep an eye out. The easy days of going to ethanol plant and ottawa are over. But did get a new wagon and the trucks all waxed
  19. IH Farms 2
    He's had it for a while think it got done this past winter he did a lot of work to it.
  20. IH Farms 2
    If the windshield is dry and you have air wipers they are probably working fine. Try with a wet windshield also of you twist the knob it controls the speed that way
  21. IH Farms 2
    Had that happen to my E6. Back in December
  22. IH Farms 2
    Would you be willing to figure out how to ship them to illinois.
  23. IH Farms 2
    Didn't notice that superliner the last 2 days coming back from Ligonier IN
  24. IH Farms 2
    I know a guy that uses them all the time has like 30 trucks. He even has 3 or 4 in stock at his shop. He's never had an issue
  25. IH Farms 2
    Was down in spring valley the last 2 days and these are sitting along rt 89 and us 6

BigMackTrucks.com

BigMackTrucks.com is a support forum for antique, classic and modern Mack Trucks! The forum is owned and maintained by Watt's Truck Center, Inc. an independent, full service Mack dealer. The forums are not affiliated with Mack Trucks, Inc.

Our Vendors and Advertisers

Thank you for your support!

Mack Related Links

Popular links

BMT Forum Logo

HTML tutorial
×
×
  • Create New...