mack88
-
Posts
128 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Everything posted by mack88
-
mine is full opening to the floor believe it is a mic mak sleeper.thanks
-
want to remove sleeper from R688 is the rubber between cab and sleeper bolted on dont want to ruin it want to install dump box.
-
Probably never get away from smoke completely a whiff is probably normal.
-
i priced one about 3 years ago was 600 and change don't why it went down in price .Haven't noticed any smoke 1450 is when it starts pulling good it always seemed as a dud before bit of head wind have to fight it,and the throttle flutter is gone to.Have a 13 speed thinking about 18 speed 13 gears are spaced a little to much.
-
Finally broke down and bought new limiter $475.00 got tired of the soot it sure pulls after 1500 rpm instead of 300 feels more like a 350 now.
-
must be red dot then.
-
That i dont know is there a tag somewhere on there its a 87
-
does anyone make the lower dash part air conditioning cover mine has the 3 round vents with slider controls and fan dial nob.
-
Thanks fellows.
-
would a 3406b cat engine fit in a 87 R Mack there's a E9 close by but pretty sure it wouldnt fit,
-
no low coolant light isn't on thanks for all your guys advise.
-
heads were were done and came back with no cracks valves were good coolant is down 1in. or so from neck bit of a head scratcher my other 350 E6 when heads were leaking it spit wet black soot out the exhaust but this one has never done that no coolant in the oil ive had it running and dont see bubbles in the rad.
-
yes new rad cap no recovery tank
-
My 87 E6 350 was pushing coolant out the over flow tube replaced air compressor last winter had heads redone with injectors i can let it idle all day wont do it but just when driving it its not much but enough to dampen the front wheel axle on the one side where the tube hangs down from the rad any where else air can enter the cooling system does have air shutters and air conditioning.
-
NICE.
-
ok pm with price if you have complete set.thanks
-
another question not sure if i should get these rebuilt or buy from Mack dont think these have ever been done price difference of about 300 a piece.
-
Thanks ill give it a try and if problematic it will go to a shop.
-
what to get my injectors redone any info on how to remove those injectors E6 4V 350 1987.
-
waking her up in the cold
mack88 replied to Lmackattack's topic in Antique and Classic Mack Trucks General Discussion
Sure sounds and looks awsome, -
Okay thanks that one will fit i am going through NAPA so i will see if they can get me one to.
-
Okay thanks seen some newer trucks have a twin cylinder compressor but thats probably for pulling trains.
-
I have a 87 mack with air ride anybody know if those compressors can keep up if your pulling a 3 axle trailer with air ride. Takeing mine off to get rebuilt or putting a rebuilt on.
-
I put 6in. in my shop rebar 12in. on square drive D6H and 320 hoe on there has held up.Up here in the winter gets down -35C few small hair line cracks no floor heat just over head heat.Think concrete guy said he used 3500 PSI concrete
-
Ordered a hub from Raneys yes it is a aftermarket steering wheel went with a 18in. after putting new air ride seat in need belly room lol .Thanks
BMT Forum Logo
