Jump to content

Recommended Posts

Just completed a trans swap from a 6 speed mack with a lo-hole to a T2090 Mack, one problem clutch stays disengaged , I have about 1" of play in pedal but clutch will not disengage , any ideas ?just thought I would see if anyone else has had this problem before I tear back into it would appreciate feed back--thanks --rocky

Link to comment
https://www.bigmacktrucks.com/topic/12458-transmission-swap/
Share on other sites

Just completed a trans swap from a 6 speed mack with a lo-hole to a T2090 Mack, one problem clutch stays disengaged , I have about 1" of play in pedal but clutch will not disengage , any ideas ?just thought I would see if anyone else has had this problem before I tear back into it would appreciate feed back--thanks --rocky

Welcome to the site

Set the clutch in order according to this buliten, then we'll talk if it dont work!

http://www.bigmacktr...ials&article=43

you may have the incorect arm for the side of the trans

sorry, don't understand low hole

Link to comment
https://www.bigmacktrucks.com/topic/12458-transmission-swap/#findComment-48785
Share on other sites

Welcome to the site

Set the clutch in order according to this buliten, then we'll talk if it dont work!

http://www.bigmacktr...ials&article=43

you may have the incorect arm for the side of the trans

sorry, don't understand low hole

2 stick 6 speed TRXL1071 with deep reduction was commonly referred to as "low hole".

.

"If You Can't Shift It Smoothly, You Shouldn't Be Driving It"

Link to comment
https://www.bigmacktrucks.com/topic/12458-transmission-swap/#findComment-48790
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...