Jump to content

Recommended Posts

So I finally got my B-75 on the road this weekend. She's got a duplex tranny, 22" rears, 4.5 ratio, and her top speed at 1900-2000 rpms was 48mph. With a tail wind she hit 49mph. I checked the ratio by counting revolutions and by looking on the Mack spec sheet. She is a single axle with a 673 engine. We were in the Granny lane and being passed like we were standing still. I think the speedometer is correct. Thanks.

:idunno:

Link to comment
Share on other sites

You need to check the numbers on the tranny to see if it's a DIRECT or OD Duplex. If it's a direct...I could see it not barely running low 50's. You need to confirm speed with another vehicle.

My single OD Triplex, 4.62 gears, 22" rubber will run ~65mph. Take the OD off and you get about 52 mph.

IMG-20180116-202556-655.jpg

Larry

1959 B61 Liv'n Large......................

Charter member of the "MACK PACK"

 

Link to comment
Share on other sites

You need to check the numbers on the tranny to see if it's a DIRECT or OD Duplex. If it's a direct...I could see it not barely running low 50's. You need to confirm speed with another vehicle.

My single OD Triplex, 4.62 gears, 22" rubber will run ~65mph. Take the OD off and you get about 52 mph.

I don't think I have overdrive---I think it is direct.java script:emoticon(':)', 'smid_2')

:) How tough is it to install OD? Thanks for the response.

I don't think I have overdrive---I think it is direct.java script:emoticon(':)', 'smid_2')

:) How tough is it to install OD? Thanks for the response.

Link to comment
Share on other sites

I don't think I have overdrive---I think it is direct.java script:emoticon(':)', 'smid_2')

:) How tough is it to install OD? Thanks for the response.

:D Look i think on the left side of tranny ,behind fill plug should be a flat spot with numbers should be a trt or trtl 72 or 720, 72 is a single overdrive a 720 is a double overdrive. If yours is a single overdrive it would be easier to find a different trans. that is a double over. terry

Link to comment
Share on other sites

Also the engine should be running at least 2100 rpm's when it's against the governor.

I've turned up rpm's to 2300 on 673's, 711's E6's etc with no ill effects.

Wont get you to 65 MPH, but will make a difference.

"If You Can't Shift It Smoothly, You Shouldn't Be Driving It"

Link to comment
Share on other sites

Guys,

While we are on the topic- you mentioned running up to 2100 on the governor- can you run on the governor and hold it without any damage to the engine? My B75 Gas firetruck has a 464 engine and has top speed of 64, I think at 2800 (no tach on the dash) can you run a gas engine on the governor like a diesel, or is that too much RPM to keep it at max?

Thanks,

Firemack

Link to comment
Share on other sites

So I finally got my B-75 on the road this weekend. ..... and her top speed at 1900-2000 rpms was 48mph. With a tail wind she hit 49mph.

And you think you're Going Too Slow.

Remember, some of us are flat out at 36mph.

Rod. :chili::chili::chili:

Proud owner of;

1961 Mack B61 prime mover.

1981 International ACCO 1810C DualCab Fire Truck

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...