aquafuzz Posted February 17, 2011 Share Posted February 17, 2011 I have a question for all.I work for Forceprotection Inc as an instructor and we build the Buffalo Route Clearance vehicle, our early trucks use the Mack ASET AI-400 engine setup. The standing procedure for shut down if the truck isnt run hard is to cycle the key off then back to run and off again to shutdown. On the first turn of the key to off starts the idle shutdown timer and by turning back to run then off causes a hard shut off.Here is my question, is this a normal operation and can this cause problems with any onboard electronics?Thanks, Quote Link to comment https://www.bigmacktrucks.com/topic/18020-mack-aset-ai-400/ Share on other sites More sharing options...
daveigou Posted February 17, 2011 Share Posted February 17, 2011 You are doing it correctly, the way it was intended with the cooldown timer enabled.The electronics aren't going to care one way or the other.Dave Quote See my Flickr photostream page http://www.flickr.com/photos/96692978@N05/ Link to comment https://www.bigmacktrucks.com/topic/18020-mack-aset-ai-400/#findComment-73033 Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.