tilynb61 Posted August 13, 2012 Share Posted August 13, 2012 I am looking to possibly change the engine in my 58 B61. It is the original END673 with a 10 speed Duplex. Engine is a bit tired, runs ok but lots of blowby, and it looks like some of the parts like the old 18 bolt head gaskets and pistons are a bit hard to find or I would just rebuild it myself. I have been reading all the info I can find on here on the swap, think I have a good idea of whats involved in swapping to a ENDT675. I have found an engine out of an older 60's MB600, wondering if there is any difference being its out of a cabover? Turbo location possibly? Any advice would be appreciated. Or if anyone knows of a parts source for the old Thermodyne that would help, would go threw the motor if I have all the parts I might need located.Thanks Quote Link to comment Share on other sites More sharing options...
Superdog Posted August 14, 2012 Share Posted August 14, 2012 Not saying it can't be done,but the MB engines were mounted at a slant,you'll have a little more parts changing to do than if you found one out of an R,DM,U etc. Quote Link to comment Share on other sites More sharing options...
umodelnut Posted August 14, 2012 Share Posted August 14, 2012 Ive noticed them MB motors were tilted. Might be a little parts changing there. Quote Link to comment Share on other sites More sharing options...
JumperAndSon Posted August 23, 2012 Share Posted August 23, 2012 All I can say is a quote from my dad: "With a cuttin' torch and a mig welder, anything can be done." Personally, if I'm fixing to swap an engine into something, it's gonna have two strokes. Just saying.Ben 1 Quote Link to comment Share on other sites More sharing options...
mackmb212 Posted August 30, 2012 Share Posted August 30, 2012 Yes the turbo is mounted alot lower on the mb and the piping from the turbo is a little more low profile for cab clearance. I can get you a few pics if you need them. Rudy Quote Link to comment Share on other sites More sharing options...
220cummins Posted August 30, 2012 Share Posted August 30, 2012 All I can say is a quote from my dad: "With a cuttin' torch and a mig welder, anything can be done." Personally, if I'm fixing to swap an engine into something, it's gonna have two strokes. Just saying.BenExcept splicing frame rails together.....def SMAW (stick) not mig. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.