bobgil Posted August 28, 2014 Share Posted August 28, 2014 I have a question about the dash in my 2001 CX613. The truck I bought does not have all the gauges that I have seen on other dashes, several of the holes in the dashdo not any gauges in them.I have been reading several different places that this is a electronic engine and all the info comes from the engine computer. How hard would it be to switch the dash gauges from another truck into my dash to have all the gauges. Quote Bob Gil If it an't a Mack could it really be a truck??? Link to comment https://www.bigmacktrucks.com/topic/36860-dash-interchange-ability/ Share on other sites More sharing options...
staxx Posted August 29, 2014 Share Posted August 29, 2014 Have to make sure you have those sensors installed like boost , egt , rear axle temp and trans temp . these should be the missing gauges , then you have to contact mack advise what sesors you have now and they will change this on the main frame at Mack. Then reprogram the vehical module with the updated software and datafile. Quote Link to comment https://www.bigmacktrucks.com/topic/36860-dash-interchange-ability/#findComment-257712 Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.