Squid Posted April 30, 2008 Share Posted April 30, 2008 (edited) It's a truck at work 2001 CL-713, the lights in the center of the dash work (valves and switches), but not the main gauge cluster. All gauges work properly otherwise. The fuses/CBs/bulbs are good. I'm just wondering if anyone has run into this before, or if it's time to start tracing the white wires?-Adam Edited April 30, 2008 by Squid Quote Link to comment https://www.bigmacktrucks.com/topic/3692-2001-cl-no-dash-lights/ Share on other sites More sharing options...
v8superdog Posted April 30, 2008 Share Posted April 30, 2008 yes i have the same problem right now in my 93 CH, its the connector on the back of the whole gauge cluster panel where the wiring harness plugs in. i had fixed it to make it work cuz its rather expensive but it quit working again. hope this helps.later on Quote 1993 Mack CH613 350 V-mac complete with Blixxton II module, RTX14710B Fuller tranny, 4.17 ratio 38K camelback rears, converted to 5-axle dump truck in 1999. Over 1 Million miles and counting on original motor Link to comment https://www.bigmacktrucks.com/topic/3692-2001-cl-no-dash-lights/#findComment-18700 Share on other sites More sharing options...
Squid Posted May 1, 2008 Author Share Posted May 1, 2008 Thanks, I'll check that out. Quote Link to comment https://www.bigmacktrucks.com/topic/3692-2001-cl-no-dash-lights/#findComment-18709 Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.