Luke Skywalker Posted January 4, 2015 Share Posted January 4, 2015 Good Evening... A Newbie here...Have a 2008 MP8 @ 417HP that developed a small oil leak recently on the right side of the engine. We have narrowed it down to the oil filter base as it was seeping out around the heads of one of the bolts.We have procured a new gasket to seal the filter base to the block. That was the easy part...Is it possible to change this gasket without removing the EGR cooler? Working with a small light and a mirror, and can't seem to get the filter base off. Gasket has 8 bolt holes in it, and we've removed 8 bolts, but something seems to be keeping it in place. Is there a common attachment or something between the EGR cooler and the oil filer base?Posted this question on an Ag Machinery forum, and one of the opinions was that the EGR cooler and turbo needed to come off.... Really? For an oil filter head gasket replacement?We purchased the truck used, and it had sat for 9 months. Been to the Mack hospital to diagnose some sensor issues, but outside of that real happy with the truck - just under 500K miles... Just want to repair a pesky oil leak.Any and all wisdom greatly appreciated...Ken Quote Link to comment https://www.bigmacktrucks.com/topic/38307-2008-mp8-engine-question/ Share on other sites More sharing options...
wheeler73 Posted January 5, 2015 Share Posted January 5, 2015 Yes unfortunately you have to remove the turbo and egr cooler. Just be carefull removing the turbo as the bolts do like to sieze up. Rember to use nickel anti-sieze on any exhaust component bolts and nuts. Quote Link to comment https://www.bigmacktrucks.com/topic/38307-2008-mp8-engine-question/#findComment-273185 Share on other sites More sharing options...
Luke Skywalker Posted January 5, 2015 Author Share Posted January 5, 2015 Thanks for the reply...Not really the one I was fishing for... Was hoping you'd say that water does run uphill if you wish hard enough...Appreciate your candor.Ken Quote Link to comment https://www.bigmacktrucks.com/topic/38307-2008-mp8-engine-question/#findComment-273237 Share on other sites More sharing options...
Mackpro Posted January 5, 2015 Share Posted January 5, 2015 Some of the steel lines that go into the oil filter stand have 2 thick orings on the ends of them. Make sure you put 2 back on as if you dont you have to remove the whole assembly again. Ask me how I know! LOL. Quote Link to comment https://www.bigmacktrucks.com/topic/38307-2008-mp8-engine-question/#findComment-273239 Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.