Jbush_51 Posted March 27, 2017 Share Posted March 27, 2017 This is my first post here but have been lurking for a while. I've got a 95 RD690 with a E7 400 electronic pump. Bought the truck a few months ago and had some issues when we bought it. Have fixed everything except the power issue. We think the engine is in limp mode. The truck starts and idles fine. But it has no power whatsoever. We've checked for boost leaks. Installed a pyrometer and boost gauge. 15 psi boost on a hard pull and pyrometer doesn't get any hotter than 5-600 degrees. The speed sensor is not hooked up and we can't find the speedometer wires going back under the truck (no twisted wires). My question is can I just not run 2 wires from the speed sensor and tie into the ecm or the harness somewhere? And if so what wires to splice into. Any help is greatly appreciated. Quote Link to comment https://www.bigmacktrucks.com/topic/49306-e7-limp-mode/ Share on other sites More sharing options...
Mackpro Posted March 29, 2017 Share Posted March 29, 2017 If enabled in the ECM programing. If you have no speedo signal it goes into limp mode. The wires go to the ECM and then out of ECM to the speedo head. Wires numbers ontop of the trans should be 11-F-16 and 11-G-16 Quote Link to comment https://www.bigmacktrucks.com/topic/49306-e7-limp-mode/#findComment-365885 Share on other sites More sharing options...
Jbush_51 Posted April 27, 2017 Author Share Posted April 27, 2017 Thanks that fixed that problem. Quote Link to comment https://www.bigmacktrucks.com/topic/49306-e7-limp-mode/#findComment-368462 Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.