Jump to content

Recommended Posts

Good afternoon, looking for help on a CXN 613 with a few codes. SID 277 FMI 9 EGR gas mass flow sensor, perform service as soon as possible, abnormal update rat. SID 27 FMI 4 Actuator for VGT, current too low or short circuit caused by malfunction, PID 412 FMI 9 Recirculated engine exhaust gas temp, abnormal update time, SID 236 FMI 4 Supply relay, current too low or short circuit caused by undervoltage.

I'm not sure where to start but I think I'll begin with the low voltage codes. The truck lost power when these codes were active, they are now inactive and power is restored. Any thoughts?

Link to comment
https://www.bigmacktrucks.com/topic/54640-05-cxn-613-egr-issue/
Share on other sites

All of these faults are voltage related. Fuse 38 powers the EECU, make sure it has battery voltage (12+ volts). Fuse 38 gets its power from the starter relay. Make sure all battery, starter and ground connections are clean. Checked the ground relay connections on the firewall as well. 

Link to comment
https://www.bigmacktrucks.com/topic/54640-05-cxn-613-egr-issue/#findComment-408394
Share on other sites

  • 3 years later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...