rjs Posted December 11, 2020 Share Posted December 11, 2020 What do I look for in replacing a E6 with a E7? Quote Link to comment Share on other sites More sharing options...
0 Joey Mack Posted December 11, 2020 Share Posted December 11, 2020 engine mounts are different.. the front on an e-6 is a yoke that fits around a snout on the timing cover.. the e-7 is a larger yoke that mounts behind the balancer, it sits on a hard rubber block or 2 rubber round mounts.... the rear mounts are on the tranny, and i cant remember the e-6 type... sorry... The e-7 will have ears that mount to the tranny that sit on 2 'figure 8' shaped frame mounts with rubber bushings sandwiched between them... thats all i have right now... the throttle linkage may need some tweeking... ... Jojo Quote Link to comment Share on other sites More sharing options...
0 theakerstwo Posted December 11, 2020 Share Posted December 11, 2020 If its a 4 valve E6 the front mount may be the same.I think Joey is thinking of a older 2 valve engine with the trunion mont on the front. Quote glenn akers Link to comment Share on other sites More sharing options...
0 Joey Mack Posted December 12, 2020 Share Posted December 12, 2020 (edited) yes sir... i was... Next time,,, I will pay closer attention to the question.... Merry Christmas, Jojo Edited December 12, 2020 by Joey Mack More content needed Quote Link to comment Share on other sites More sharing options...
Question
rjs
What do I look for in replacing a E6 with a E7?
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.