Black truck Posted February 4, 2021 Share Posted February 4, 2021 I eliminated this and went with a straight shaft. It has 2 worn gears and a bad bearing. Looking to see if any one would be interested in it. Shifter and shifting rods with it to. Quote Link to comment https://www.bigmacktrucks.com/topic/65782-spicer-brownlipe-gear-box-5831/ Share on other sites More sharing options...
0 Rob Posted February 4, 2021 Share Posted February 4, 2021 That is a hard one to find parts for being so small. What variant is it? There could be A-D available, and these determine ratios. Thanks for offering it up before arbitrarily scrapping as someone may make use of it. Quote Plodding along with no job nor practical application for my existence, but still trying to fix what's broke. Link to comment https://www.bigmacktrucks.com/topic/65782-spicer-brownlipe-gear-box-5831/#findComment-468280 Share on other sites More sharing options...
0 Black truck Posted February 5, 2021 Author Share Posted February 5, 2021 I'm not sure. Not to familiar with it. It came out of my 77 ford f500 5speed 2 speed axle 390 engine. The serial# is 124 719. S/m#300010. Model#5831. 55-15-59. How can I figure out the variant and ratio. Quote Link to comment https://www.bigmacktrucks.com/topic/65782-spicer-brownlipe-gear-box-5831/#findComment-468311 Share on other sites More sharing options...
0 Rob Posted February 5, 2021 Share Posted February 5, 2021 There is very much possibility the 5831 series had no sub variants so that may be it only. Usually the "A" series were a deep reduction, and the "B" was not so much as example. That was specified by the original purchaser, or whomever ordered the truck. Don't think I've seen an auxiliary trans in a truck with a two speed rear myself. Quote Plodding along with no job nor practical application for my existence, but still trying to fix what's broke. Link to comment https://www.bigmacktrucks.com/topic/65782-spicer-brownlipe-gear-box-5831/#findComment-468313 Share on other sites More sharing options...
0 Black truck Posted February 5, 2021 Author Share Posted February 5, 2021 I haven't either. I replaced it with straight shaft. Had to make a bracket for the carrier bearing but it seems to be doing fine. Quote Link to comment https://www.bigmacktrucks.com/topic/65782-spicer-brownlipe-gear-box-5831/#findComment-468316 Share on other sites More sharing options...
Question
Black truck
I eliminated this and went with a straight shaft. It has 2 worn gears and a bad bearing. Looking to see if any one would be interested in it. Shifter and shifting rods with it to.
Link to comment
https://www.bigmacktrucks.com/topic/65782-spicer-brownlipe-gear-box-5831/Share on other sites
4 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.