Mack parts

[cruiseliner64]

Hi all.just a few questions...

1)front axle wheel seals and oiler caps...Mack part numbers are  32 QF 245 oil seal and 120 MF 268 oiler cap.19QF324 oiler cap gasket

Can anyone tell me the Stemco part numbers for those parts.

2)is this the gearbox oil check/filler bung on the Maxitoqure box and is the gearbox and range changer lubed by the same oil as there is a square head bung on it too.just being careful as i had a disaster a few years ago with a 4X4 where what i thought was a filler bung turned out to be part of the gear selector .. result...box out for a rebuild🥶 .. 

PAUL

[mrsmackpaul]

2) answer is, all the same oil

1) I can look tomorrow if it is of any help 

 

Paul 

[h67st]

I don't know if this diagram looks like your Maxitorque, but as you can see there's a magnetic plug (some have them on both sides) and a filler plug. Also you can go to the link below for a maintenance manual for the TRL1076:

https://www.progearandtransmission.com/Mack-Maxitorque-Transmission-TRL1076-Manual.pdf

[cruiseliner64]

Hi,thanks for your answers h67st,mine is a 107 series and that diagram you sent is spot on.Paul if you could look them up tomorrow that would be great...im a Mack rookie so doubke checking everything.

Thanks guys.Paul.

[mechohaulic]

the hex 6 sided plug is as stated a magnetic one. remove that plug for inspections.it will (should) have a round magnet attached to it. anything on the magnet then very carefully while wearing rubber gloves one finger in the opening feel the trough for debris. is common for the magnets to have minor metal not pieces. the square headed plug is the filler. removing the hex plug oil may seem to run out. that is only the oil laying in the trough.

[cruiseliner64]

Thanks.i'll remove both plugs and check them and then check the oil level through the square head plug.thanks for the tips.

Paul