Jump to content

Recommended Posts

I changed filter cartridges and oil lines on the two canister filters on my ENDT 673 engine.I filled both filters with oil.That was six weeks ago.Finally started it,and after 30 seconds of idling,zero oil pressure,according to the gauge.I would always get 60 psi showing within 5 sec.The dash gauge appears to be fed from a line going to the turbo.Is there a way to positively check that I have or don`t have pressure in the engine? Thanks.

Link to comment
Share on other sites

Oil spurted out of the big filter when I opened the vent and cranked the starter,but no oil going to the turbo feed line,and therefore none to the gauge.If anyone in northwest NJ is interested in a pretty nice single axle B61,I`m ready to move on.

Link to comment
Share on other sites

Don't sell your truck!  If you had oil pressure before your oil change, you should still have oil pressure. You probably need to bleed air out of the filter.  Do you have the large full flow/ bypass filter? That is the one with 3 lines on the bottom. If you had some oil come out the vent, you must have some pressure. They can take a bit to get all of the air out as I recall. There are several places on the drivers side of the engine where you can pull out a plug and install a test gauge, if you need to. Good luck.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...