mackcl96 Posted March 17, 2009 Share Posted March 17, 2009 I went to turn the truck up today and I noticed that relating to the 4 screws that hold that top rear cover on, 3 are regular screws that came out easy, the 4th looks like a factory rivet thingy. Does that sound right? I imagine that i would need to pry the cover off at the same time that it hopefully prys that rivet out of the hole? I knew I should of taken a picture of it.It is a 24 point bolt because Robert Bosch don't want you in there.Your local pump shop will have the socket for you Quote Thanks for hearing me out.You can have the soap box now---------JIM Link to comment https://www.bigmacktrucks.com/topic/8638-turn-up-237/page/2/#findComment-32286 Share on other sites More sharing options...
niceguypmp3 Posted June 6, 2010 Author Share Posted June 6, 2010 Alright guys, I finally got around to using a chisel and hammer to get that special screw out so that I could finish getting the cover off and then i find out that it doesn't look like what was being explained. I'll post the pic on here that I took. It looks like there are a couple bolts that are attached to a long adjusting screw from the back that you can see in the image. It has 2 screws that hold the whole assembly down, but it doesn't look like it can slide without hitting the gasket for the cover. I was afraid to move anything after seeing what it looked like. What do you all think? Thanks in advance!! Quote Link to comment https://www.bigmacktrucks.com/topic/8638-turn-up-237/page/2/#findComment-56673 Share on other sites More sharing options...
fjh Posted June 20, 2010 Share Posted June 20, 2010 Alright guys, I finally got around to using a chisel and hammer to get that special screw out so that I could finish getting the cover off and then i find out that it doesn't look like what was being explained. I'll post the pic on here that I took. It looks like there are a couple bolts that are attached to a long adjusting screw from the back that you can see in the image. It has 2 screws that hold the whole assembly down, but it doesn't look like it can slide without hitting the gasket for the cover. I was afraid to move anything after seeing what it looked like. What do you all think? Thanks in advance!!Try loosening the bolt on top turn the screw on the( end one) turn tighten the bolt and try it! ( Note )I beleive ya turn that one counter clock wise to increase!You can always put it back where it was if you don't get the results your after! Quote Link to comment https://www.bigmacktrucks.com/topic/8638-turn-up-237/page/2/#findComment-57832 Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.